Safety Instructions - Lupine Sl F Bedienungsanleitung

Safety instructions

Warning!
Avoid looking directly into the light emitted by the light or shining the light into
your own eyes or the eyes of another person. If the light accidentally shines
into your eyes, close your eyes and move your head out of the light beam. Do
not use any strongly focusing optical device to look at the light beam.
In cases where the light is used in a public or commercial setting, users should
be provided with training concerning the safety measures for laser light.
This device may then be used by children 8 years of age or older, persons
with limited physical, sensory or mental capabilities, as well as persons with no
previous experience in handling such devices, if they are supervised by a person
responsible for their safety.
Carry a spare light with you at all times, as the product can potentially fail
unexpectedly at any time.
Defects:
Light source must be replaced in general if the light source (or one of the LEDs)
is defective.
Heat generation:
The housing of SL may heat up; so make sure that you always keep the light
at a safe distance to any combustible or flammable materials. Could cause fire
or death! However, quiescent operation (without cooling the light housing via
airflow or the like) is possible at any time and will not damage the product.
Water resistance:
All SL components are waterproof and can of course be used under extremely
severe conditions. The lamp complies with IP protection class 68 but is NOT a
diving lamp and is NOT suitable for use under water.
Cleaning:
Do not use a strong water jet or heavy detergent to clean the lamp.
1.
1. Position the upper half of the mount on the left side of the stem.
2. Bring both halfs together.
3. Tighten the screw max. 0.5 Nm.
4. Put the o-ring on to the bolt screw, then both through the hole of the mount.
Now slide the second o-ring on to the bolt screw.
(Image 4: Longer screw of the optional extension kit)
Assembly
2.
3. 4.