Herunterladen Inhalt Inhalt Diese Seite drucken

Operation; Checking The Battery Charge Level; Removing / Inserting The Battery; Switching On And Off - Deltafox DP-CRS 2022 Originalbetriebsanleitung

Akku-säbelsäge
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
chuck (3). Ensure that the saw
blade is securely attached and
that the teeth point downwards.
3. Release the clamping lever (4).
Check that the saw blade is se-
cure by pulling on it.
Removing the saw blade:
4. Turn the clamping lever (4) as far
to the right as possible and hold
it firmly in this position.
5. Remove the saw blade from the
chuck.
6. Release the clamping lever.
For certain work, the saw blade
can also be inserted after turning
through 180°.

Operation

When working with the device,
always wear suitable cloth-
ing and appropriate protective
equipment.
Prior to each use it must be en-
sured that the device is working
correctly.
Personal protective equipment
and a fully functional device re-
duce the risk of injuries and ac-
cidents.
After the device has been
switched off, the blade contin-
ues moving for some time. Do
not touch the moving blade and
do not attempt to brake it. Dan-
ger of injury!
Checking the battery charge
level
The battery's (
cated by the charge state indicator (
The LEDs indicate the battery's charge
level. To do this, press the softkey (
14) of the charge level indicator (
red-yellow-green => Battery fully
red and yellow => Battery half charged
red
=> Battery needs

Removing / inserting the battery

1. To remove the battery (11) from
the appliance, press the release
button (12) on the battery and
pull out the battery.
2. To insert the battery (11), place
it on the guide track and push
it back into the appliance. It will
audibly snap in.
Do not insert the battery until
the appliance is fully assembled.
Risk of injury!

Switching on and off

Ensure your stance is stable and
hold the device tightly with both
hands and away from your body.
Before switching the device on,
ensure it is not in contact with the
work piece.
Switching on:
1. Ensure that the battery (11) is
inserted (see "Removing/insert-
ing the battery").
11) charge level is indi-
charged
to be charged
GB
13).
13).
27

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis