Badabulle B014405 Anleitungen Zur Benutzung Seite 8

IMPORTANT! READ CAREFULLY AND KEEP FOR FUTURE REFERENCE
EN
COMPOSITION
A- Receiver
B- Transmitter
C- 5V DC 1000mA Power adapter X 2
(a) : B014405SAV600
(b) : B014405SAV601
The a b spare parts are available with our custumer
service (services@badabulle.com).
CONTROLS
• TRANSMITTER
1- Camera lens
2- Infrared sensor
3- Microphone
4- Antenna
5- Loud-speaker (VOX Function)
6- ON/OFF power switch
7- DC Jack socket
8- Start-up indicator light
9- Pairing button
• RÉCEPTEUR
10- Menu (zoom: right)
11- Microphone: "mummy speaks to baby" function (zoom: left)
12- 2.4" LED Screen
13- VOX mode activated indicator light
14- Loud-speaker
15- Start-up indicator light
16- Microphone
17- Zoom +/-
18- Volume + ( zoom: up)
19- Volume – (zoom: down)
20- Belt clip
21- Stand
22- Lithium battery 3.7V 850mAh
23- Visual alarm
24- DC Jack socket
25- ON/OFF power switch
USE
• TRANSMITTER
1- Plug the adapter (C) into the DC Jack socket (7) on the
transmitter (camera) and connect it to a power socket.
The transmitter can be powered from the mains using the
5V DC adapter provided.
2- Press the ON/OFF power switch (6).
3- The indicator light (8) under the switch turns green to tell
you that the camera is switched on.
4- Position the transmitter so that is faces baby, but is out of
his/her reach, preferably at a distance of approximately
1 metre. With the help of the stand under the transmitter,
it is easier to turn your camera towards baby. You can
also fix the camera to the wall.
• RECEIVER
PLEASE NOTE: Before using the receiver for the first time,
recharge the lithium battery provided for at least 4 hours. Be
careful to switch the unit completely off before charging the
battery for the first time. Run time in VOX mode: 11hr. Run
time in continuous mode: 6hr.
1- Place the receiver at a reasonable distance (too close
creates audio feedback, producing a Larsen effect in the
loud-speaker).
8
3
3
2- Plug the adapter (C) into the DC Jack socket (24) on the
receiver and connect it to a power socket.
3- Press the ON/OFF power switch (25) to turn on the
receiver. The power indicator light (15) will turn green.
4- To reassure baby, you can use the «Microphone» button
(11): keep the button pressed down while speaking to
3
baby. The sound is broadcast over the transmitter so baby
can hear you. Release the «Microphone» button (11) to
hear baby again.
5- The volume is adjusted using buttons
Press directly on these buttons to increase or decrease
the volume. The volume level will appear on the screen to
allow you to see what you have selected.
6- You can zoom using button
zoom using button:
To move it to the right
To move it to the left
To move it up
To move it down
(19) and (18).
(17). You can move the