G-Lab MD2200 Gebrauchsanweisung Seite 48

1. Pull the battery cover located on the bottom side on
the unit as shown in figure.
2. Remove old batteries and insert new ones. Use
LR03 or AAA alkaline batteries and use batteries
of same type only.
3. Make sure the battery polarities (+) and (-) match
the making on the battery compartment.
INSTALL/ CHANGE BATTERIES
4. Place back the battery door.
NOTE:
• Insert the batteries as shown in the battery
• [
• When battery power becomes weak, the [
• Never use rechargeable batteries. This may
• Battery life may vary with ambient temperature and
48
compartment. If not, the device will not work or
even be damaged.
] icon represent battery power is enough.
and "E6" appears in the display, replace all batteries
with new ones. Do not mix old and new batteries.
damage the unit.
may be shorter at low temperature.
] icon