Maintenance - Zee TASMAN Gebrauchsanleitung

MANUAL
X 4
3
ENGLISH
X 4
TASMAN
CONTENTS
→ The hose trolley (zinc coated steel
with powder coating) consists of
2 parts:
· Frame with 50 m hose (PVC
and rubber = REACH tested)
and hose clamp
· Handle, U-shaped tube
→ The white bag contains the
accessories and parts:
· Connector x 2 (ABS)
· Connector with water stop x 1
(ABS)
· Tap adapter x 3: ½", ¾" and
1" (ABS)
· Spray gun (ABS)
· Nozzle (ABS)
· Set of screws x 5 (1 = spare):
cylinder and screw (chrome-
plated stainless steel)
· Spare cap for crank end
ASSEMBLY
→ Slide the handle over the frame.
→ Slide a cylinder from the set of
screws (accessory bag) into one of
the 4 holes and tighten a screw into
the cylinder.
Repeat for the 3 other holes.
The direction in which the sets are
screwed into the holes is not impor-
tant, but we think the smooth side
facing outward is more attractive 
→ To connect the hose trolley to the
tap, cut the hose on the trolley to
the required length:
· Determine the length and cut to
size.
· Place the connectors from the
accessories bag (without the
water stop) on both ends.
· Screw the matching adapter
(from the accessories bag) on
to the tap.
· Click the hose on to the tap and
the hose trolley.
→ Place the remaining connector
with the water stop on to the
hose on the trolley.

MAINTENANCE

→ Use a soft, lint-free cloth or sponge.
→ Use a solution of warm water and
a small amount of mild, pH-neutral
detergent.
→ Rinse all cleaned surfaces
thoroughly after cleaning.
REMARKS
→ It is advisable to store the hose
trolley indoors in winter, especially
in freezing temperatures.
→ If you leave the hose trolley outside
in freezing temperatures, ensure that
all water has been drained from it.
→ Make sure to store the nozzle and
spray gun indoors, as they may
crack when the water inside
freezes.
→ It is best to store the hose trolley
dry and away from direct sunlight
when not in use to lengthen its
lifespan.
50 m
4