Faults And Remedies - jbc PK Bedienungsanleitung

ENGLISH
When you assemble the suction cup with
the needle, you should avoid the needle to
stick out of the lower part.
Start-up
The unit is switched on with the switch at
the side.
Suction regulation
Locate the suction control in the required
position, from less to more, taking as a
guidance that in position 5 (maximum),
40% vacuum is obtained.
Component pick-up
Hold the pencil vertically in one hand. Place
the needle tip on the component and block
the control orifice with the first finger of the
other hand so that the component may be
held to the needle by suction.
Component placing
Place the component in position on the
printed circuit. Remove your finger from
the orifice allowing air to enter whereby
the component will be released in the
desired position.

FAULTS AND REMEDIES

We list below the most frequent faults and
the possible remedies which you yourself
may be able to apply. In any case, the JBC
technical assistance service will attend to
you if required.
Insufficient suction
Check that there are no leaks and all the
tubes are well inserted home. If in spite of
this the suction is insufficient, the vacuum
pump should be checked.
Pump does not work
Check that there is current in the mains.
The green LED should be iluminated.
Check the fuse. If it has blown, it should be
replaced with another one of the same
rating.
JBC reserves the right to alter specifications without prior
notification.
2