Fan Heater - Vitek VT-1751 BK Betriebsanweisung

FAN HEATER

Description
Base
1.
Front grid
2.
Display
3.
Control panel
4.
Carrying handle
5.
Inlet filter
6.
Inlet filter grid
7.
Power cord
8.
Tip-over switch
9.
Control panel
Oscillation function On/Off button
10.
On/Off button
11.
Timer/Delayed start On/Off button
12.
"Time/temperature decrease/increase" but-
13.
tons «+» «-»
Operating mode selection button
14.
Display
"ECO" mode icon
15.
"Fan" mode icon
16.
"Timer/Delayed start" function icon
17.
Indoor temperature indication icon
18.
"Anti-freeze" mode icon
19.
Remote control
On/Off button
20.
"Time/temperature decrease/increase" but-
21.
tons «+» «-»
"Timer/Delayed start" On/Off button
22.
Operating mode selection button
23.
Oscillation function On/Off button
24.
ATTENTION!
Always observe the main safety measures when
using electric units, as below:
– Read this instruction manual carefully.
– Use the fan heater according to its intended
purpose only.
– Before switching on the unit for the first time,
make sure that the mains voltage corresponds
to the voltage specified on the unit body.
– The heater must not be located immediately
below a socket-outlet.
– Do not insert the plug into defective or worn-
out sockets.
• In order to avoid fire do not use adapters for
plugging the unit in.
• In order to avoid network overloading, provide
that no other electrical appliances with higher
VT-1751 IM.indd 3
power consumption are connected to the
same outlet the fan heater is connected to.
• Place the unit on a flat and steady surface.
• Do not place the unit on a soft surface, for
example, sofa or bed.
• The distance between highly inflammable
substances, curtains or furniture etc. and the
front grid of the fan heater must be at least
0,9 m.
• Avoid blocking the air inlet grid of the fan
heater by any objects or room interior ele-
ments.
• Do not switch the fan heater on in places
where aerosols or highly inflammable liquids
are used.
• Do not cover the fan heater during operation.
• Do not insert any foreign objects into the
grids of the fan heater in order to avoid get-
ting injuries or damaging the unit.
• Do not use the fan heater in a limited space
(for example, in built-in cabinets or wall nich-
es - for tubes defrosting or to prevent them
from freezing).
• Do not use the unit outdoors.
• Do not leave the operating fan heater unat-
tended.
• Do not leave the fan heater switched on when
sleeping.
• Unplug the unit if it is not used.
• Always unplug the unit before cleaning.
• Before removing the plug from the socket
set the operation modes switch to the posi-
tion "OFF".
• When unplugging the unit, pull the plug but
not the cord.
• Do not touch the power plug with wet hands.
• Do not immerse the unit into water or other
liquids.
• Do not use the unit in bathrooms or in rooms
with high humidity.
• Do not place the unit in places, where it can
fall in a bath or other container, filled with
water.
• If some water gets on the unit body, unplug
it before touching, then wipe the unit with a
dry cloth.
• In order to avoid burns avoid contact of open
body parts with hot surfaces of the grid and
outgoing hot air.
• Do not use the power cord for carrying the unit.
• Do not wind the power cord around the unit
body.
3
ENGLISH
04.06.2012 14:11:10