juju Safe Rider Benutzungsanweisungen Seite 10

If the height of your shoulder belts in child car seat is not fit for your child, adjust
the height of the shoulder belts. Please proceed as follows:
Step 1: loosen the harness(see point 4.3). Turn the child seat to the
1.
back(Fig. 4.1.1).
2. Step 2: Slide both ofthe harness off the harness connector (Fig. 4.1.2).
Step 3: Now you can pull both chest pads and shoulder belts forward
3.
through the belt slots carefully (Fig.4.1.3).
Step 4: Now thread the small belts of the chest pads and harness into
4.
the corresponding belt slots.(fig. 4.1.4).
Step 5: Slide both of the chest pads and slide the harness straps in the
5.
harness connector.
Ensure that the belt is positioned correctly twisted.
4.2. Securing the child car seat(group I)
Step 1: Place the child safety seat on the vehicle's seat which is fitted with 3-
1.
point safety belts ensuring it is firmly pressed against the car seat backrest(Fig.
4.2.1).
2. Step 2: Pull out the vehicle belt, Thread the belt tongue (incl. Vehicle belt)
through the Adult belt route slot to the rear and through the back rest.,
through the other Adult belt route slot(on the buckle side). and allow it to lock
in place. You will hear "click"(Fig. 4.2.2.).
Step 3: Place the vehicle lap belt under the arm rest. Note: Pull the vehicle
3.
diagonal belt on the vehicle buckle side and the vehicle lap belt under the arm
rest.
Make sure adult belt has not become twisted(fig. 4.2.3).
Step 4: Press your knee on the child car seat and pull the diagonal belt along
4.
the direction as the picture shows(fig.4.2.4). Make sure that belt has not
loosened. Tighten the diagonal sh-oulder belt in the direction of the
automatic roll-up as possible.
The satisfactory position of the adult safety-belt buckle relative to the child car seat
is as the Fig 4.2.5. You can contact the child car seat manufacturer if in doubt about
this point.
Page 10