Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ATTENTION: THE ILLUSTRATIONS THIS
USER'S MANUAL REFERS TO CAN BE
FOUND ON THE LAST PAGE OF THIS
MANUAL.
INSTALLATION
Power supply:
1. Slide down the battery cover at the rear
of the indoor unit and remove it.
2. Place 2 batteries, type AAA, 1.5Volt,
according to the markings inside the
battery compartment (see A). Batteries
are not included.
After you've installed the batteries, the indoor
unit will start scan of 3 minutes for any nearby
outdoor unit. That's why you should follow the
instructions 4, 5 and 6 within those 3 minutes.
3. Unscrew the battery cover with a
crosshead screwdriver.
4. Place 2 batteries, type AAA, 1.5Volt,
according to the markings inside the
battery compartment (see B).
5. Set the channel switch to your desired
transmitting channel 1, 2 or 3.
Please select the same channel on the indoor
unit that you've set on the outdoor unit.
MAX/MIN
6. Press the "
CH
indoor unit, placed above the battery
。
C l
compartment. Each time you press this
button, the receiver will change to the
next channel.
The display will show which channel
number is selected.
To make the outdoor unit transmit again:
7. Press the "TX" button (see C) to have
the outdoor unit transmit again when the
registration has failed.
EN
page 2/4, indoor unit, screening
" channel button of the
。
F
As soon as both the indoor and outdoor unit
have been found, the outdoor temperature
will appear on de display of the indoor unit
(see D).
8. Now replace the battery covers on the
indoor and outdoor unit.
9. Both units can be suspended from a
screw (see E) or placed on a surface
using the foldable table support (see F).
Temperature display setup:
The temperature unit can be expressed in
ºC or ºF. Press the "
between ºC and ºF.
Maximum and minimum display:
De minimum temperature measured and the
v1.1
maximum temperature measured can be
displayed.
•
Briefly press the "
the minimum temperature.
•
Briefly press the "
show the maximum temperature.
•
Press and hold "
to reset the maximum and minimum
temperature.
Positioning tips:
•
Never place the indoor unit in direct
sunlight and keep it away from heat
radiating objects (lights, heaters, etc.)
•
Never place the indoor unit next to
large metal surfaces or heavy electrical
equipment, ensuring proper reception of
the radio controlled signals.
•
The outdoor unit is not waterproof.
Always place this unit on a spot protected
against rain and wind.
•
The distance between the indoor and
outdoor unit should be no more than
50 meters.
11
page 2/4, indoor un
page 2/4, indoor un
MAX/MIN
page 2/4, indoor unit
CH
" button to switch
。
C l
。
F
" button to show
MAX/MIN
CH
" button again to
MAX/MIN
。
C l
。
F
CH
" for two seconds
MAX/MIN
。
C l
。
F
CH
。
C l
。
F
Werbung
Inhaltsverzeichnis
