Manual Tune - Denver DAB-56C Bedienungsanleitung

2. Press and hold one of the Preset button until the display shows 'Preset empty x' (where x is the
preset number)
3. Press ENTER/AUTO-SCAN to store the current chosen frequency.
TO RECALL A PRESET STATION
1. Short press the PRESET button
Note: The unit can store 10 stations for DAB & 10 stations for FM
Note: To use memory 5~8 function, you shall press the shift key first and then press the
PRESET1~4 buttons together.
INFO
The UNIT has DAB information modes which are shown on the bottom line of the display. Short
press the INFO key to see the available types.
1. program type
Displays the type of station content being broadcast e.g. Classic, Pop, News, etc.
2.Ensemble Freq.
Displays the DAB station frequency such as 13F 239.200MHz.
3.Audio Bit Rate
Displays the data rate in kilo Bits per second and the audio mode e.g. Stereo.
4. Ensemble name
Displays the name of the multiplex to which the Digital1 Network current station belongs
5. Signal strength
Displays the signal strength for the station being listened to.
6. Time/Date
Displays current time and date, received off-air.
7. DLS (Dynamic Link Segment)
Scrolling text which includes messages such as Artist and track name, phone numbers,
program details, etc.
FINDING NEW STATIONS
As and when new stations are introduced it will be necessary to do an auto-scan in order to
detect and store the new stations.
1. Short press the Auto-tune button on the rear of the unit to start an auto-scan. "Autotune Full
Scan" will be displayed
2. DAB services are generally localised, so if you move the UNIT to a different area it will be
necessary to do an auto-scan in order to pick up stations in the new local.

MANUAL TUNE

Manual tuning allows you to tune directly to a DAB station.
1. Long press the ENTER button until the display shows 'Manual Tune'
2. Short press the UP or DOWN key to select a different channel number
Please note: You may have to wait for the UNIT to tune in to the new channel.
OPERATING THE UNIT IN FM MODE
1. Fully extend the telescopic antenna.
2. Press the POWER (ON/OFF) switch to "ON" position to enter standby mode.
3. Short press the STANDBY button to switch the unit on.
4. If the UNIT is in DAB mode, short press the DAB/F,M to change to FM.
The UNIT remembers the selected source when switched to Standby and automatically selects
it the next time it is switched on. If the power is disconnected the UNIT will always select DAB
mode when first switched on.
5. The display shows the current tuning frequency and information line.
ENG-5