Operation; Specifications - First Austria Fa-8100 Benutzerhandbuch

SENSOR SOAP DISPENSER
SAFETy INSTRUCTIONS
1. please read these operation instructions carefully
before using the device. pay attention to avoid damage
due to improper use.
2. keep these instructions for future use.
3. if the device is passed on to a third party include these
instructions with the device.
4. do not open the casing. never attempt to repair the
device yourself. For repairs consult a specialist.
FEATURES
1. rinse cycle allows for easy cleaning
2. infrared sensor activates the device
3. removable drip tray collects residual droplets
4. 3 aa batteries required (purchase separately)
5. Flip-up top reveals a large opening for easy refilling
6. Adjustable selector lets you choose the desired amount
of liquid soap lcd screen shows dispensed amount,
remaining liquid soap level and remaining battery power
PARTS see Fig.a
1. lcd display
2. + button
3. - button
4. top cover
5. dispenser body
6. liquid soap nozzle
7. infrared sensor
LCD
1. dispensed amount: shows the dispensed amount
2. remaining liquid soap level: shows the remaining liquid
soap level; it will alert by flashing until you refill the liquid
3. remaining battery power: shows the remaining battery
power; it will alert by flashing until you change the
batteries
ChANGE BATTERIES
1. open the battery compartment, see Fig. 2.
2. install 3 x 1,5V aa batteries. observe correct polarity
(+/-).
3. close the battery compartment, see Fig. 3.
REFILL LIQUID SOAP
1. open the top cover.
2. Refill liquid soap as shown in Fig. 4; do not fill over MAX
marking.
3. close the top cover
2
a) Wall mount funtion:
mount the dispenser on the wall. Fig. 5

OPERATION

1. insert the batteries in the battery compartment as
described in chapter "change Batteries"
2. press the - button several times until the lcd shows
"POWER OFF", the infrared sensor is turned off
3. Refill liquid soap as described in chapter "Refill Liquid
soap"
4. press the + button until "dispensed amount" shows on
the lcd, as shown in Fig. 1
5. place your hands under the dispensing nozzle. the
built-in infrared sensor will detect your hand and the
device will automatically dispense the selected amount
of liquid soap. the dispenser can dispense soap for a
pre-set time, which can be set for more or less soap.
press the + or – buttons to change the "dispensed
amount" on the lcd.
6. Caution: At first time use dispense several times to
make the soap run from the nozzle.
CONTINUOUS DISPENSING
press and hold the + and - buttons at the same time for
about 6 seconds, the dispenser will continuously dispense
for about 30 seconds. Fill the dispenser with water for
cleaning.

SPECIFICATIONS:

Batteries: 3 x 1.5V aa batteries
Min capacity: 40ml
MAX capacity: 200ml
Environment friendly disposal
You can help protect the environment! please remember
to respect the local regulations: hand in the non-working
electrical equipments to an appropriate waste disposal
center.
3