SEA SIGNAL BOX UNI Handbuch Seite 7

Number of codes which
can be memorized:
Number of channels:
CH1/CH3:
CH2/CH4:
Working temperature:
Storage temperature:
Dimensions:
Humidity:
Radiocontrol learning
- Push P1 button to access the programming mode
and select the chanal to be stored.
- CH(X) led will switch on
- Push the selected button on the transmitter
- CH(X) led will flash to confirm the memorization and it
will stay switch on until it will receive a new code (other
transmitter).
- Store further radio transmitters or press repeatedly
P1 to light all leds and wait for about 4 sec. to leave the
programming mode.
Attention: the first stored radio transmitter will set the
receiver in Roll Standard (TX STANDARD) or Roll Plus
(TX PLUS) or FIX CODE mode. It is not possible to use
different TX types with the same receiver.
Deleting a single remote control
Press repeatedly P1 to light the LED relative to the
channel from which to delete the remote control. Press
the button on the transmitter to be canceled. The LED
flashes 4 times to confirm the deletion.
67410907
800 (Roll Plus) / 30 (other TX)
2/4
N.O. Free Contact
N.O./N.C. Free Contact
-15°C - +60°C
-40°C - +80°C
46 x 65 mm
from 5% to 90% no
condensation
Rev.00 - 05/2012
7