Herunterladen Inhalt Inhalt Diese Seite drucken

Using The Scooter; Control Functions; Battery Status Display - B+B Centuro S4 Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Centuro S4
| Scooter

4. Using the scooter

After you have adjusted the scooter according to your height, familiarise
yourself with the functions of the controller.

4.1. Control Functions

The controller is a component of the steering column of your scooter. It
contains LED displays and functional elements.
Hazard warning lights
Diagnostic LED
Headlight
Battery indicator
Indicators
Speed setting
Ignition lockl
Horn
Hazard warning lights
Use this button (Fig. 14) to switch on the hazard warning lights in
emergency situations where it is not possible to drive the scooter. All
four indicator lights then flash and signal to other road users that your
scooter cannot be driven.
14
52
Speed setting
You can use these buttons (Fig. 15) to set the maximum speed.
Turn the switch to the left (turtle) to reduce the maximum allowed
speed.
Turn the switch to the right (rabbit), to raise up to the maximum
allowed speed.
Headlight
Use this button (Fig. 16) to switch on the lights on your scooter when
dusk begins to fall or when passing through dark routes such as tunnels.
This will make you more easily visible to other road users.
Diagnostic LED
If the diagnostic LED is constantly lit (Fig. 13) the scooter is fully
functional.
If a fault occurs, this is indicated by flashing. First check the battery
status and whether the drives are connected. If the LED continues to
flash, contact your mobility dealer.

Battery Status Display

The battery status display (Fig. 17) shows to what extent the batteries
are charged. If all ten bars are visible, the battery is fully charged.
As you use the scooter, the battery capacity decreases and fewer bars
are displayed. If only two bars are displayed, this means that only short
journeys can now be made and the battery should be recharged (see
charging).
13
Indicators (left/right)
Use this button (Fig. 18) to switch on the left or right indicator on your
scooter to signal to other road users that you wish to turn left/right.
Pressing the button again turns the indicator off again. After flashing
15 times the signal turns off automaticly.
Bischoff & Bischoff GmbH |25.11.2019 - Revision: 1
Centuro S4
Scooter |
15
16
17
18
53

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Centuro s2

Inhaltsverzeichnis