Chapter 4 : Technical Specifications; Chapter 5 : Wall Mounting - Analog Way Rk251 Bedienungsanleitung

Chapter 4 : TECHNICAL SPECIFICATIONS

REMOTE PORT
Level:
Data Rate:
ENVIRONMENTAL
Power Supply:
Temperature:
Hygrometry:
Dimension:
Weight:

Chapter 5 : WALL MOUNTING

To install the REMOTE KEYPAD in a standard 2-gang electrical box, proceed as follow :
Remove the front panel of the REMOTE KEYPAD (4 screws).
Disconnect the 5 pin screw male terminal from the REMOTE KEYPAD'S PCB and disconnect the 4 wires from the 5
pin screw terminal.
Connect the new cable on the 5 pin screw terminal as shown below:
PCB OF REMOTE
KEYPAD
TX
RX
OV
12V
• Connect TX on PIN 3 of the SMART FADE's DB9 connector,
• Connect RX on PIN 2 of the SMART FADE's DB9 connector,
• Connect OV on PIN 5 of the SMART FADE's DB9 connector (only 1 wire is necessary),
• Connect 12V on PIN 8 of the SMART FADE's DB9 connector.
Connect the 5 pin screw terminal to the PCB of the REMOTE KEYPAD and install the front panel into the standard 2-
gang electrical box.
Secure the front panel with the 4 screws.
PAGE 8
RS 232
9600 Bauds, 8 data bits, 1 stop bit, no parity bit
+ 12V dc (by the SMART FADE's DB9 connector)
Storage : - 25°C to + 85°C
10% to 80% (without condensation)
W 117 x D 115 x H 55mm / W 4.6" x D 4.5" x H 2.16"
0.5 kg / 1.1 Lbs
SMART FADE
DB9 F CONNECTOR
REMOTE KEYPAD FOR SMART FADE™