Startup / Operation - BOMANN KSG 235 Bedienungsanleitung

Flaschen-kühlschrank

Vorschau ausblenden

Inhalt

Inhaltsverzeichnis

Verfügbare Sprachen

Electrical connection

WARNING:

• The installation to the mains supply must conform

to the local standards and regulations.

• Improper connection may cause to an electric

shock!

shock

• Do not modify the appliance plug. If the plug does

not fit properly to the outlet, let install a proper

outlet by an authorized specialist.

• The accessibility of the power plug must be en-

sured in order to disconnect the appliance from

the power supply in case of an emergency.

CAUTION: : : :

CAUTION

In case of disconnection or power failure:

wait for approx. 5 minutes before restarting;

check the operation settings.

• Ensure that your mains power corresponds with

the specifications of the appliance. The specifica-

tions are printed on the rating label.

• Connect the mains cable to a properly installed

and earthed wall outlet.

Reverse the Door Opening

If required, the door opening can be moved from the

right (delivery condition) to the left side.

WARNING:

When replacing the door stop, the appliance must be

disconnected from the power supply. Always unplug

the appliance first.

NOTE: : : :

NOTE

• When installing, ask another person to assist.

You possibly need:

•

driver as well as a thin-blade screwdriver.

electric

screw wrench, Phillips screw-

• Remove the cover (a) of the upper door hinge (b)

and dismount it by loosening the screws under-

neath.

• Open the appliance door a little and take it care-

fully of the lower door hinge. Place the door on a

padded surface to prevent it from scratches.

• Move the cap (c) to the opposite holes.

• Tilt the appliance slightly backwards and block it

in this position. Unscrew the feet. Dismount the

lower door hinge (d) and the holding device (e) by

loosening the screws.

• Rotate the hinge (d) and the holding device (e)

about 180° and replace the items after you have

unscrewed the hinge pin and used by the other

hinge side. Tighten all screws and turn in the feet

accordingly.

• Replace the appliance upright again. Insert the

appliance door on the lower hinge pin and fix the

door to the property position.

• Transfer the upper door hinge (b) accordingly. Put

the hinge pin in the hole of the appliance door and

tight the hinge. Put on the hinge cover (a) again.

• Check if the door is arranged vertical as well as

horizontal, so that a smooth opening and closing

of the door is ensured.

• Dismount the door handle and attach it to the

corresponding other door outer side. Refer to the

instructions in "Assembling the door handle".