After Use; Additional Information; General Advice; Insert Block Removal - Techne TECAL 700XS Anleitung

Inhaltsverzeichnis

When you have finished heating samples, remember that parts of the unit, inserts and associated

accessories may be very hot. Take the precautions listed earlier. We recommend that the inserts should

be allowed to cool to 70°C before being removed from the Tecal 700XS unit. They will still have to be

handled with care.

If you need to remove an insert while it is hot, fit the extractor tool into the locating holes and lift the

insert out carefully. Never leave the extractor tool in the insert while it is being used in the Tecal unit.

Brief fault finding notes and lists of replacement parts, accessories and inserts for the Tecal are given in

this section.

NOTE THAT THIS EQUIPMENT SHOULD ONLY BE DISMANTLED BY PROPERLY TRAINED PERSONNEL.

REMOVING THE OUTER COVERS EXPOSES POTENTIALLY LETHAL MAINS VOLTAGES.

THERE ARE NO OPERATOR SERVICEABLE PARTS WITHIN THE EQUIPMENT.

In the unlikely event that you experience any problems with your Tecal which cannot be easily remedied,

you should contact your supplier and return the unit if necessary.

Please include any details of the fault observed and remember to return the unit in its original packing.

The slim insert block must be removed from the unit and packed separately within the case. Techne accept

no responsibility for damage to units which are not properly packed for shipping: if in doubt, contact your

supplier.

HELP display

If HELP is displayed there is a problem with the internal sensing device. The cooling will come on and cool

the unit down. The calibrator should be returned to your supplier for repair.

The unit is fitted with an over-temperature cut-out. It will operate if a fault develops and the unit exceeds

its maximum operating temperature. The cut-out will remove power to the heaters and return the unit to

ambient temperature. The heater LED will still be illuminated continuously but the temperature displayed

will decrease. If the cut-out has tripped

and then switching it on again

If the unit is switched off and then switched on again quickly this may also cause the over-temperature

cut-out to trip. If this occurs, turn the unit off, wait 5 seconds or more then switch it on again. Repeated

tripping of the cut-out may indicate a fault and you should contact your supplier for more information.

AfTEr uSE

it can be reset by switching the unit off, waiting a few seconds

to reset it.

Inhaltsverzeichnis