Werbung
FAR_94195_Invader_14L_IM_051815.pdf 9 18/5/15 2:48 pm
PLEASE CHECK THE HEADINGS I - IX WITH THE DIAGRAMS IN
1. Insert antenna wire from product into tube.
2. Slide tube down antenna wire and into hole in product.
3. Tie knot with any remaining antenna wire (Do not pull wire tight).
WARNING!
1. To remove battery lid, loosen screw to open.
2. Slide open the battery lid in the direction as shown in the figure, while lightly pressing its center.
3. Insert 1,5V (AAA/LR03) batteres x3 with the polarity (+/-) as shown on the bottom of battery
compartment.Replace the battery lid, following the removal procedure in reverse.
NOTE:
C
There is no on/off switch on the Transmitter. Moving the sticks turns it on automatically.
M
Y
CM
1. Fully charge 4,8V NiMH battery pack in advance of your use.
2. Turning off vehicle.
MY
3. Turn the latches located underneath of vehicle to unlock battery lid as shown in the figure with
CY
arrows.
4. Remove battery lid.
CMY
5. Insert 4,8V battery pack into battery compartment with correct polarity (+/-). Place battery lid
K
back in position and lock properly.
NOTE:
To remove the batteries, reverse the installation procedure.
WHEEL ALIGNMENT.
FORWARD
A
BACKWARD
B
LEFT TURN - FORWARD (Push at the same time)
C
RIGHT TURN - FORWARD (Push at the same time)
D
LEFT TURN - BACKWARD (Push at the same time)
E
F
RIGHT TURN - BACKWARD (Push at the same time)
NOTE:
After play, always turn vehicle off. Remove batteries from controller and R/C vehicle when not
in use or when storing. Leakage may occur and cause damage if left for a long period of time.
PAGES 1, 2, 3, 4.
I - ANTENNA ASSEMBLY
THE ANTENNA IS NOT TO BE INSERTED INTO SOCKET-OUTLETS!
II - TRANSMITTER BATTERY INSTALLATION
III - VEHICLE BATTERY INSTALLATION
IV - OPERATING R/C VEHICLE
TURN VEHICLE POWER ON.
GB
7
Werbung
