Denver ASA-30 Handbuch Seite 8

You hear one beep: the accessory has been connected to the siren
successfully (if you hear 3 beeps, the accessory has already been
connected).
The siren supports up to 10 remote controls and 10 wireless detectors.
Test
a) Test the connection to a remote control
Press the "Arm" button on the remote control. The siren beeps once: the
connection of the remote control is successful. If not, the connection
has failed, try registering the remote control again.
b) Test the connection to a wireless sensor
Arm the system. Trigger the sensor (e.g. walk in front of the sensor
if you have connected a motion detector). The siren rings out: the
connection of the sensor is successful. If not, the connection has failed,
try registering the sensor again.
Clear all accessories
Press the Connect button on the siren for 6 seconds until you hear two
beeps. The LED light on: all accessories and control panel connected to
the siren have been cleared.
8