Mounting The Hood Body - Style Tradition HB9T Bedienungsanleitung

• Drill ø 8 mm holes at all the centre points marked.
• Insert the wall plugs 11 in the holes.
• Fix the brackets using the 12a screws supplied.
• Insert the two screws 12a supplied in the hood body fixing holes, leaving a gap of 5-6 mm between
the wall and the head of the screw.
• Fix the back panel (where present) using the 12a screws supplied.
• Before attaching the hood body, tighten the two
screws Vr located on the hood body mounting
points.
• Hook the hood body onto the screws 12a
provided.
• Fully tighten support screws 12a.
• Adjust screws Vr to level the hood body.
• Assemble the two halves of the hood body
extension piece 14
• Push fit the assembled hood body extension piece
14 onto the air outlet
• Push fit connection 15 onto the hood body
extension piece 14
• Insert the connection extension pieces laterally
14.1 in connection 15
• Make sure that the outlet of the extension pieces
14.1 is horizontally and vertically aligned with
the chimney outlets. If this is not the case, adjust
the position by either reversing the connection
extension pieces 14.1 or by cutting the hood body
extension 14 along one of the thinner section
channels denoting the pre-fixed lengths, then
reassemble as described previously.
• The air outlet directional grills must be fitted after
the lower chimney section 2.2 has been installed.
• Ensure that the activated charcoal filters have
been inserted.
17

Mounting the hood body

Connections
RECIRCULATION VERSION AIR OUTLET
12a
15
14
Vr
14.1
GB