Technical Information - Microlab FC10 Benutzerhinweise Und Sicherheitshinweise

Connections
1. Connect the left speaker to the rear DC jack (SPK OUT ) of the right speaker (main) .
2. Place both speakers on extreme sides of the listening position.
3. Connect the playback device to the rear 3.5 mm stereo input with the included signal cable.
4. The playback device such as CD/DVD, Mp3/Mp4 player or T V can be connected to the speaker
system.
5. Last, connect the AC power adapter to the rear of the right speaker (DC IN) and to the AC power
supply source. Please ensure the AC power supply match the power requirement printed at the
rear panel.
Operations
1. Ensure the master volume is at the lowest setting.
2. Turn on the main AC power and switch on the speaker system from the side power switch of the
right speaker.
3. Start the playback device and song.
4. Adjust the volume on the media player, and speaker master volume to your preferred listening
level.
5. Depress the + or - buttons on the side of the speaker to adjust the volume level.
Note: it is advisable not to turn the volume too loud or to its extreme volume limit to avoid
damage to the speaker driver material and impair your hearing.
EN
5
Ideal listening position
and placement
FL - front left
FR - front right

Technical Information

Amplifier
Total Power: 30 Watt RMS
Power distribution: 15 Watt x 2
Harmonic distortion: < 0.5 % 1 W 1 kHz
Frequency response: 80 Hz - 20 kHz
Signal/Noise ratio: > 65 dB
Separation: > 45 dB
Speakers
Tweeter type: 0.5" x 2
Tweeter rated power: 5 Watt x 2 8 Ohm
Woofer type: 2.25"
Woofer rated power: 15 Watt x 2 8 Ohm
Interfaces
Output: Proprietary audio DC plug
Input: 3.5mm stereo jack
Frequently Asked Questions (FAQ)
Questions
During adjustments, the LED will blink.
LED status during volume
adjustments
Once reached range limits, the LED will remain
steady.
Check if the audio source is properly paired and
connected. Secondly check if the 3.5mm stereo
plug is correctly inserted.
No Sound
Ensure volume is correctly adjusted
Check the 3.5 mm stereo cable for proper connection
Intermittent sound
and cable is firmly inserted
LED illumination LED on the main speaker indicates power on status.
Any playback devices such as PC, notebook with USB slot,
What are the products
CD/DVD player, Media Players with 3.5mm stereo plug.
supported?
Check if the volume is at lower level and the Mp3
Sound is distorted
format is recorded at above 196 bitrate
It is magnetically shielded so can be placed
Where to place this speaker
near LCD TV Monitor without any distortion
If the problem still exists, please contact the distributor or ask for professional service
Answers
EN
6