Safety Regulations; Items Supplied; Intended Use - EINHELL KDK 1 Bedienungsanleitung

Anleitung_KDK_1_D_SPK7:_
Important!
When using the equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating instructions and
safety regulations with due care. Keep this manual in
a safe place, so that the information is available at all
times. If you give the equipment to any other person,
hand over these operating instructions and safety
regulations as well. We cannot accept any liability for
damage or accidents which arise due to a failure to
follow these instructions and the safety instructions.

1. Safety Regulations

Working on a roof can be dangerous. We
therefore strongly recommend having the roof
support mounted by an experienced technician.
Apply a properly fastened and intact safety
harness before you access roofs or places where
there is the risk of falling!
Make sure that the roof is able to bear your
weight. Never walk on decayed or unstable
surfaces! Wear strong, slip-resistant shoes.
Only use ladders and other climbing aids which
are in proper working order. Do not build
makeshift climbing towers!
If there is a risk of objects falling on passers-by
from above during the installation process you
must cordon off the danger zone.
Check for overhead lines in the vicinity of the
point of installation. Touching overhead lines can
cause fatal injury!
Never work on the roof when a thunderstorm is
approaching or during a thunderstorm. There is a
risk of fatal injury!
It is imperative that all lightening safety
regulations in force in your country are adhered
to. Earthing and lightening protection work may
only be carried out by specialist electricians due
to the risk of sub-standard results!
Never carry out earthing and lightening
protection work if you are not a specialist with the
corresponding knowledge and expertise.
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
21.01.2009 13:21 Uhr Seite 5

2. Items supplied

Item
A
B
C
D
E
F
G
H
I
L
M

3. Intended use

The roof support is designed for mounting split-
system air conditioners up to a total weight of 140 kg.
The roof support is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Description
4 x Base mount
2 x Horizontal connecting profile
2 x Vertical connecting profile
2 x Fastening profile
2 x Stay
2 x Assembly bag F containing:
4 x Screw M8 x 15
4 x Washer
4 x Bracket 50x25x13 M8
2 x Assembly bag G containing:
4 x Screw M8 x 35
4 x Washer
4 x Bracket 50x22x13 M8
1 x Assembly bag H containing:
6 x Screw M6x16
6 x Spacer tube Ø12x46
6 x Washer
6 x Self-locking hex nut M6
1 x Assembly bag I containing:
2 x Dowel with eyebolt
2 x Chain for anchoring
1 x Assembly bag L containing:
8 x Anti-vibration rubber for basic mount
1 x Assembly bag M containing:
4 x Screw M8 x 35
4x Self-locking hex nut M8
4 x Washer
4 x Anti-vibration rubber
GB
5