User Manual - TOM-Audio TG-200
4.8. TOM-Audio TG-100ST
4.8.1. Installation and setup
Use only the supplied AC adapter to ensure
safe operation. Plug the power adapter into
the TG-200ST and plug the power cord into
the power outlet.
4.8.2. Connect the antenna
Connect either the standard dipole antenna ANT-D1 or
the optional directional period antenna ANT-100WD to
the RF OUT at the rear of the stationary transmitter.
4.8.3. Operation
1.
Press the On / Off switch (No. 1) to turn on the TG-200ST. When the display is
illuminated, the system is ready for use. Press the power button again to turn off
the TG-200ST.
2.
Turn the knob (No. 2) to adjust the volume. Turn the control all the way to the
left to mute.
3.
Turn the knob (No. 3) left or right to adjust the audio balance of the transmitted
signal. When two different audio sources are connected to the rear panel AF in-
put L (I) / R (II), use this control to set the source you want to send. Turn the knob
45
45