Heinner VCMP002 Anleitung Seite 4

Thank you for choosing Heinner!
!
Important
When using equipment, a few safety
precautions must be observed to avoid injuries
and damage. Please read the complete operating
manual with due care. Keep this manual in a safe
place, so that the information is available at all
times. If you give the equipment to any other
person, give them these operating instructions as
well. We accept no liability for damage or
accidents which arise due to non-observance of
these instructions and safety information.
GENERAL SAFETY INSTRUCTIONS FOR ELECTRIC
TOOLS
Caution!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
may result in an electric shock, fire and/or serious
injury.
Workplace safety
Keep your work area clean and well illuminated.
Do not operate the electric tool in an environment
where there is a risk of explosions and where there
are inflammable liquids, gases or dust.
Keep the electric tool out of the reach of children
and other persons.
Electrical safety
The connector plug from this electric tool must fit
into the socket.
Avoid bodily contact with earthed surfaces such as
pipes, heating, ovens and fridges.
Keep the tool out of the rain and away from
moisture.
Do not use the cable to carry the electric tool, to
hang it up or to pool it out of the socket. Keep the
cable away from heat, oil, sharp edges and moving
parts of the appliance. If you are working outdoors
with an electric tool, only use extension cables
which are designed specifically for this purpose.
If operation of the electrical tool in a damp
environment cannot be avoided, use an earth-
leakage circuit-breaker.
Safety of persons
Be careful, watch what you are doing and use an
electric tool sensibly. Do not use the tool if you are
tired or under the influence of drugs, alcohol or
medication.
Wear personal protection equipment and always
wear safety goggles.
Make sure that the appliance cannot start up
accidentally.
Remove the keys and wrenches before switching
on the electric tool.
Avoid abnormal working postures. Make sure you
stand squarely and keep your balance at all times.
Wear suitable work clothes. Do not wear loose
clothing or jewelry.
If vacuuming devices and draining devices can be
fitted, make sure that these are correctly attached
and correctly used.
Usage and treatment of the electric tool
Do not overload the appliance. Use the correct
tool for your work.
Do not use an electrical tool with a defective
switch.
Pull the plug out of the socket and/or remove the
battery before making any adjustments to the
appliance, changing accessories or put the
appliance down.
Keep unused electric tools out of the reach of
children.
Make sure to use electric tools, accessories,
attachments, etc. in accordance with these
instructions. Take the conditions in your work area
and the job in hand into account.
Additional safety instructions for compressors
Before connecting the compressor to the power
source, make sure that the power supply
parameters match the information on the
compressor identification plate. If the voltage is
too high, serious injuries and equipment damage
COMPRESSOR
3