Problems And Solutions - Zen Aroma ESSENSIA Bedienungsanleitung

VI.

PROBLEMS AND SOLUTIONS

If the diffuser does not operate properly under normal conditions of use, consult the
following table:
Problems
If there is no light.
No blowing, no
Main switch off.
mist,
The water level in the reservoir is too
no indicator
high (>100 ml).
lights
Water is leaking from the reservoir.
No water in the reservoir or the
reservoir does not contain more than
Blowing, but
20 ml.
no mist
The temperature of the unit is too low.
Mist with an Water has been stagnating for too long
unusual smell in the reservoir.
Too much water in the reservoir.
The mist intensity control has set to
minimum.
Sediment on the ceramic disk.
Low intensity
The water is too cold.
The water is not clean.
The mist intensity control has set to
The mist does
minimum.
not come out
The reservoir and the base are not
(or not
connected properly.
enough).
The fan isn't working properly.
Possible causes Solutions
Check the device is plugged in or that there
is not a power failure.
Switch on the main switch.
Remove some water from the reservoir.
Check that the lids are closed properly.
Fill the reservoir with fresh water.
Place the unit in a room at ambient
temperature for half an hour before use.
Clean the reservoir and fill it with fresh
water.
Remove some water from the reservoir.
Adjust the control button.
Clean the ceramic disk.
Use water at ambient temperature.
Clean the reservoir and fill it with fresh
water.
Adjust the control button.
Check their connection.
Ask a specialist to check the fan in the base.
EN
12