Installation - Indel B KD 50 ECOSMART Gebrauchsanleitungen

INSTALLATION

Remove the caps (2 pcs each side)
Fix the cabinet with screws (2 pcs each side)
Insert the caps
WARM SUGGESTION
No need to remove the drawer when installation.
Confirm the position is right before screw in.
VENT IL AT I ON
The compressor cooling system lets out heat and needs good ventilation. Therefore places with
bad ventilation are not very suitable. The Minibar must be installed in a place with an opening
which guarantees the necessary exchange of air, and it is of the utmost importance not to cover
up or obstruct the grids which provide the device with proper ventilation. One must also avoid
positioning it in a place which is directly exposed to sunlight or to other heat sources.
200 cm
80 mm
2
WARNING
You must fit the Minibar into the cabinet,
guaranteeing a cross section at the air
inlet and outlet of at least 200 cm
33
.
2