Troubleshooting Guide - MAGNETIC JE301 Bedienungsanleitung

To cancel the Scan function and
display just one specific value, press
the MODE key and the arrow will stop
flashing on the chosen function.

TROUBLESHOOTING GUIDE

Problem: The display comes on but
only the Time function works.
Solution:
a. Make sure that the connection
cable is connected.
Problem: The display does not come
on or the displayed segments are very
weak
Solution:
a. Check that the batteries are fitted
correctly.
b. Check the battery charge
c. If they are run down change them
immediately
Problem: Display segments of a
function read-out are not visible or
error messages
function appear.
Solution:
a. Remove
seconds and then refit them correctly.
b. Check the battery charge If they
are run down change the batteries
c. If the above steps do not help then
replace the electronic monitor.
Avoid leaving the electronic monitor in
direct sunlight as this might damage
the liquid crystal display. Similarly, do
not expose it to water or knocks.
Do not hesitate to get touch with the
Technical Assistance Service if you
have any queries by phoning customer
services (see last page in manual)
INTERSPORT
RIGHT TO
SPECIFICATIONS
PRODUCTS
NOTICE.
6
for a particular
the batteries
RESERVES
MODIFY
OF
WITHOUT
for 15
THE
THE
ITS
PRIOR