Fitting The Batteries - MAGNETIC JE301 Bedienungsanleitung

FITTING THE BATTERIES

Remove the insulating strip located on
the back of the monitor for batteries
make contact and make sure the
monitor is turned on.
This monitor
ALKALINE BATTERIES. To fit the
batteries Fig.1, carefully insert the two
"R-6" type batteries into the battery
compartment (A), Fig.2, making sure
that the battery's polarity is correct
(matching the battery's "+" terminal
with the "+" sign inside the battery
compartment, and the "-" terminal with
the "-" sign). Replace the battery
compartment cover.
If, after having switched the monitor
on, it displays errors or merely partial
segments then remove the batteries
and wait for about 15 seconds before
reinstalling them.
Weak batteries (run down) produce a
weak digital display (poor contrast)
and erroneous readings. Change them
immediately.
Important. Used batteries must be
discarded in special containers. Fig.3.
ELECTRONIC MONITOR
The screen will switch itself on
automatically as soon as you start
exercising or by pressing any key on
the monitor. The monitor switches on
as soon as you start to exercise on the
machine.
The monitor will switch itself off
automatically if the unit stands idle for
more than 4 minutes,
uses two 1.5
English
MONITOR FUNCTIONS Fig. 4.-
MODE
Key for selecting on-screen monitor
functions.
volt Pressing the MODE key for 2 seconds
will reset all of the monitor values,
except for the total number of strokes.
COUNT.
strokes since the monitor was set
back to zero using the MODE key.
COUNT / MIN.
This indicates the number of strokes
being produced per minute.
CALORIES
A tally of the number of calories being
burnt during the exercise.
TOTAL COUNT
A tally of the total number of strokes
made during the various exercise
sessions. This can only be set back to
zero by taking the batteries out of the
monitor.
TIME
Measures the time that has elapsed
during the exercises.
SCAN
Scans through the following functions
every
Strokes per minute; Calories; Strokes
and Time.
Press the MODE key until the arrow
moves onto SCAN, press the MODE
key and the Scan function will be
displayed with the arrow flashing.
5
Counts the
6 seconds: Total
number of
strokes;