cam IL MONDO DEL BAMBINO LE MANS Gebrauchsanweisungen Seite 8

INSTRUCTIONS fOR USE
IMPORTANT! Read the instructions carefully and keep for future
reference. Your child' s safety could be at risk if you do not follow
the instructions. IMPORTANT! Only use the product for the purpose
that it was designed for. Should the product be used for any other
purpose the manufacturer declines all responsibility. Never use
replacement parts other than those supplied or approved by Cam
Il Mondo del Bambino, as this could cause damage to your product
and make it unsafe. IMPORTANT! Cam Il Mondo del Bambino S.p.A.
reserve the right to alter or modify any product for technical or
commercial reasons without prior notice. WARNING! Never leave
the child unattended in the car seat! WARNING! This car seat must
be replaced in case of impact caused by car accident.
This is a "UNIvERSAL" car seat, and is approved to ECE Regulation R 44, for
general use in motor vehicles. This car seat will fit most, but not all motor
vehicles. • A correct fit is likely if the vehicle manufacturer has declared in
the vehicle hand book that the vehicle is suitable to accept a "UNIvERSAL"
child restraint for this age group and weight. • This car seat has been
declared as "UNIvERSAL" under more stringent test conditions than those
applied to earlier designs which do not carry this notice. • In case of doubt
please contact your retailer or the manufacturer • This car seat can only be
used if your vehicle is fitted with a 3 point safety belt approved to UN/ECE
Regulation No 16 or other equivalent standard. • The safety of your car seat
can only be guaranteed if the instructions have been followed correctly and
the car seat has been fitted accordingly. • do not place unrestrained objects
on the rear panel or rear seat of the vehicle, as this could cause injury in case
of braking or an accident. Ensure that all luggage or objects that could cause
a potential hazard in the case of an accident are firmly secured. • All
passengers should be aware of how to release the child from the car seat in
case of danger or an accident. The car seat should be replaced immediately
if involved in an accident. • Pay particular attention, that neither the car seat,
nor any of it's parts, become trapped or crushed, in doors or mechanism of
the motor vehicle. • The safety belt used must be pulled tight to remove any
slackness, and the car seat harness, must be adjusted correctly to fit the
childs body. Ensure the the belts are not twisted in any way! • Pay attention
to the fitting of the abdominal belt, ensuring that it is positioned low down,
to ensure that the pelvis is held firm and correctly protected. • Even when
travelling without a child, the car seat must be fully restrained at all times.
• do not use the car seat without the fabric upholstery covering. • The fabric
upholstery must not be replaced with any other than original parts, or those
recommended by the manufacturer, as this constitutes an integral part of
13
the restraining system. • The upholstery can be washed in warm water (max
30°), with a mild neutral detergent. do not tumble dry, do not iron, and do
not use solvents. • Should any problems arise during the fitting, or use of
this product, contact the manufacturer. • Please note that group 1-2-3
stage car seats can be used on the front seat and are exempt from the
regulation of not being fitted when an airbag is active, as per Regulation
ECE R 44. We would however recommend that this car seat only be used on
the rear seat of your vehicle. • Use of the car seat is subject to standard ECE
R 44. Certain limitations prevail over this standard and are imposed by local
or national laws.
INSTRUCTIONS fOR USE
GROUP 1: 9-18 KGS (fIG. 2)
Put the car seat on the floor with the backrest against the wall and place the
child inside. Check the height of headrest and shoulder straps on the basis of
the height of your child (fig. 5a & 5b). Otherwise please read the next step:
hOW TO AdJUST ThE hEAdREST:
hold the plastic plate situated behind the backrest (fig. 6), then push button "X"
up or down on the basis of the height of your child, until mechanism is locked
in one of the five available positions (fig. 7). N.B.: Adjust the headrest on the basis
of the height of your child, so to allow the best side protection.
hOW TO AdJUST ThE ShOULdER STRAPS:
Loosen the harness as shown in fig. 8. Take right and left belt off from part "Y"
situated behind the backrest (fig. 9). Take shoulder straps off and insert them into
new slots, make sure shoulder straps are pushed first through headrest slots
and then backrest's ones (fig. 10). ATTENTION: fOR A CORRECT USE, hEAdREST
ANd BACKREST SLOTS MUST MATCh. Reinsert the shoulder straps into part "Y"
(fig. 11).
hOW TO INSTALL ThE CAR SEAT (GROUP 1)
Place the car seat in the car and insert the vehicle seat belt behind the backrest
through vertical slots B & C, situated in the car seat backrest as shown in fig.
12a & 12b. The diagonal vehicle belt d must restrain the car seat backrest, and
part A must be positioned under the armrests "E" (fig. 12c). N.B.: make sure the
belt is not twisted. Push the car seat again the vehicle seat and simultaneously
pull the diagonal belt d upward (fig. 13a & 13b).
INSTRUCTIONS fOR USE
14