Atlantis +CamHD 7000-Serie Kurzanleitung Seite 16

ENG
+CamHD7000 has also included a kit for wall mounting. Unscrew the base and
remove the metal disk as shown above.
Fix the hard plastic on the wall, using 2 screws. Screwed to the base the plastic
support and then attach it, tightening the special articulated joint, to the rear of the
camera.
+CamHDMotor7000 It can be placed on a flat surface or fixed to the wall via the
KIT for fixing to the wall. Fix the plastic support to the wall / ceiling, using 2 screws.
Block the base to the plastic support, after connecting the power plug
+CamHDOutdoor7000 It can be fixed to the wall through the KIT for wall
mounting. Once screwed to the wall and oriented, you can connect the power
supply.