Assembly - IKA R 2722 Betriebsanleitung

H-Stands
Pic. A
Pic. B
14

Assembly

4.1
H-feet
Screw the two side parts (4.1) to the bridge (4.2) (see pic-
ture A).
4.2
3.1
Screw the adjusting screw (3.1) with lock nut (3.2) into the
right-hand side part and put on the cap (3.3) (see picture
3.2
B).
The three rubber feet must be glued under the stand legs,
which do not have an adjusting screw.
3.3
H-feet stand rod mounting
5
Degrease the conical surfaces, apply glue and drive the
stand rod (1) firmly into the bridge (4.2) (use a rubber
hammer or soft intermediate layer).
Put on the cap (5).
1
4.2
R 2723 telescopic stands
5
Insert the stand rod (1) with the cone into the bridge (4.2)
(the knurled screw (Fig. 2.2) is on the side. Tighten the
screw (6) over the washer (7). The O-ring (8) is positioned
as a buffer over the bridge (4.2).
Put on the cap (5).
1
2
8
4.2
7
6
The telescopic tube must
CAUTION
not be directed at people.