To Fill The Gun From Bulk Container - Lincoln PowerLuber series Handbuch

Models 1860, 1862, 1862E, 1864
PowerLuber Grease Gun (Lithium)
Installing Grease Cartridge
1. Unscrew the grease tube assembly from
the PowerLuber.
2. Visually check the follower seal lip direc-
tion before loading a new cartridge. The
follower seal lip must be directed toward
the follower handle or rear side for
cartridge loading. See Fig. 5. (To change
the direction of the follower seal, unscrew
tube cap from grease tube assembly and
pull on the handle to remove follower seal
from tube. Flip follower seal over and
reassemble.)
3. Pull back on the follower handle and latch
the follower rod groove into the slot on the
tube cap.
4. Remove the plastic cap from the grease
cartridge and insert cartridge into the
container tube.
5. Remove the pull tab from grease cartridge
and screw grease tube assembly into
pump assembly.
6. Thread grease tube assembly back onto
the Powerhead.
7. Release follower rod from slot. Purge
air from pump. See air purging instruc-
tions.
8. Reset display reading after purging air.
Air pockets in the cartridge lubricant will
cause the gun to lose its prime and will
cause grease output measurements and
cartridge level readings to be inaccurate.
(See page 8).
Removing Empty Grease Cartridge
1. Pull back on the follower handle until the
follower rod is fully extended and latch the
follower rod groove into the slot on the
tube cap.
2. Unscrew the grease tube assembly from
the PowerLuber.
3. Carefully release the follower handle to
eject the empty cartridge from container
tube.
To Convert Gun to Allow Filling From
Bulk Containter or Filler Pump
1. Unscrew the grease tube assembly cap
from the grease tube assembly. Pull on the
follower handle to extract the follower and
spring from the grease tube assembly.
2. Grasp follower between thumb and forefin-
ger and flip the follower lip from the rear to
the front side.
NOTE. The follower resembles a cup.
Page Number - 8
When the gun is assembled for use with
bulk lubricant, the cup opens toward the
pump assembly.
3. Reassemble follower into grease tube and
tighten onto the container tube.
Rear Side
Figure 5

To Fill The Gun from Bulk Container

1. Remove pump assembly from grease tube
assembly.
2. Pack lubricant into cavity of the pump as-
sembly.
3. Insert the open end of the grease tube
assembly into lubricant (see Fig. 6). Slowly
pull the follower handle back while pushing
the grease tube assembly deeper into the
lubricant to prevent air pockets from being
pulled into the grease tube.
4. When the follower rod is fully extended,
pull it sideways to latch the rod groove
into the keyhole slot in the grease tube
assembly cap.
5. Loosely assemble the pump to the grease
tube assembly. Release the follower
rod from the grease tube assembly cap
and disengage the follower rod from the
follower by rotating the follower handle.
Push the follower rod into the grease tube
assembly. Slowly unscrew the grease tube
assembly from the pump until lubricant
oozes from the interface. Tighten grease
tube assembly into the pump assembly.
6. Reset display reading after purging air
Figure 6
Front Side
Form 404264