Installation Concerns; Aeroplane Installation; Installation In An Aircraft - Auna Pipa Icon Handbuch

Installation Concerns

This PIPA icon infant child restraint with the Base is
suitable for vehicle seats with i-Size ISOFIX anchor
points. (1)
DO NOT place rear-facing PIPA icon infant child
restraint on front seat with air bag. Death or
serious injury may occur. (2) Please reference
vehicle owner's manual for more information.
DO NOT install this PIPA icon infant child restraint
on vehicle seats that face sideways or rearward
with respect to the moving direction of the vehicle.
(3)
It is recommended to install this PIPA icon infant
child restraint on the rear vehicle seat. (4)
DO NOT install this PIPA icon infant child restraint
on vehicle seats unstable during installation.

Aeroplane Installation

The Nuna PIPA icon can only be installed using a
2-point safety belt if being used in an aircraft.
DO NOT install in a vehicle using a 2-point safetybelt.
When being used in an aircraft, the child restraint
must only be installed rear facing on the seat.
Nuna child restraint width is 450mm, but some
aircraft seat widths are 430mm. For narrow seat,
please place padding under the seat to raise the
height and allow it to fit between the arm rests.
19
Installation in
an Aircraft
1 Position carrier so that child is facing the aircraft
seat. (42)
2 Route the aircraft lap belt under both lap belt
guides and buckle. (42)
3 Adjust the angle of the carrier. A rolled up towel
or foam pool noodle may be used to help adjust
the amount of recline. The angle is correct when
the blue line is level with the floor of the aircraft.
4 Tighten the aircraft belt while pushing the carrier
firmly into the seat. (43)
20