MaxiPool Kleen-Machine Pool Scrubber KM01EU Bedienungsanleitung Seite 2

REMOVING THE CLEANER FROM THE POOL
• Slowly pull the blue cord to get the cleaner to the pool surface and near
the edge of the pool. DO NOT PULL THE CLEANER OUT OF THE POOL BY
THE CORD.
• Reach down and grasp the handle of the cleaner and remove it from the
pool as shown below.
FIGURE 1: Grasping Handle
The unit should be stored in an area that will afford some protection from the
elements to insure that it retains its finish.
CLEANING THE FILTER BAG (Filter Bag Should Be Cleaned After Every Use.)
• Turn cleaner upside down and place on ground so the bottom lid is exposed.
• Turn red locking pegs (by wheel area) to the unlocked position as shown in Fig 3. Next
press the two red locking clips near the roller brush in
towards the center of the unit. Lift the bottom lid out.
FIGURE 2: Lift from Pool by Handle
FIGURE 3
• Hold the bottom lid as shown in Fig 4 and pull the tab marked "PULL TO REMOVE BAG"
• Turn filter bag inside out and hose off all debris as shown in Fig 5. If very dirty it may
be washed in your washing machine, inside out, with cold water, mild detergent, and
by itself.
• Hose all debris off the bottom lid being sure to get all dirt out of the fine filters on the
intake doors as shown in Fig 6.
2
FIGURE 4
FIGURE 5
FIGURE 6