Epson SureLab D-3000 Benutzerhandbuch Seite 11

CleanDtheDwiperDthatDisDusedDforDcleaningDtheDprintDhead.D
O
Note:
• Be careful not to drop the cleaning stick into the printer.
• Do not touch the tip of the cleaning stick to any other parts except for the wiper.
• The wiper is made from elastic materials. Be careful not to flip the wiper with the cleaning
stick; otherwise the dirt on the stick may scatter.
• Make sure that the end of the cleaning wiper does not touch the parts inside the printer
while cleaning.
Tip:
We recommend using a light when cleaning the wiper because the wiper area is too dark to
see.
Step 1. Use the cleaning stick to wipe the surfaces indicated by
cloth to remove any dirt on the stick. Repeat 5 times.
Step 2. In the same way, use the cleaning stick to wipe the surfaces indicated by
Use the BEMCOT cloth to remove any dirt on the stick. Repeat 5 times.
Step 3. Use the cleaning stick to wipe the surfaces indicated by
there is any dirt on the surface of the wiper, remove it with the BEMCOT cloth.
Repeat until all dirt has been removed.
- PRINTHEADDMAINTENANCEDKIT
11
-
. Use the BEMCOT
and again. If
EN
.