Camry CR 9606 Bedienungsanweisung Seite 4

3. Do not bend or deform perforated blade protector.
4. Exercise extreme caution when pulling out blades.
5. Wipe the shaver body with dry cloth.
6. The lint bin should be emptied when it is 3/4 full.
7. Deposit on the inner and outer surface of cutting film decreases the shaving efficiency.
Clean the film regularly with a brush.
8. Flatten the fabric surface before using the shaver.
9. Do not press the shaver in the clothing, as this may damage the fabric.
10.Do not use the shaver on the clothes that you are wearing, always remove them before
using the shaver. Otherwise the body or shaver damage may occur.
11. Always switch the shaver off before plugging in the power adaptor or changing the
batteries.
12.The shaver is equipped with a safety lock. The shaver cannot be turned on, if the film is
installed improperly or is not properly tightened.
13.Make sure not to use shaver on buttons, zippers, applications, stripes, stickers, labels,
abrasions, seams or fasteners.
14.Do not use shaver to remove lint from the silk, wool or linen fabrics. This can damage the
fabric as well as the shaver blades.
15. Never use this device close to water, e.g.: Under shower, in bathtub or above sink filled
with water.
16. If using the device in bathroom after use remove the power plug from the socket,
because water proximity presents risk, even if the device is turned off.
17. Do not allow the device or power adaptor to wet. If the device falls into water,
immediately remove the power plug or power adaptor from the socket. If the device is
powered, do not put hands in the water. Have the device checked by the qualified
electrician before using it again.
18. Do not touch the device or power adaptor with wet hands.
19. The device has to be turned off after every use.
20. Do not leave the device unattended, if it is connected to power socket.
21. In order to provide additional protection, it is recommended to install residue current
device (RCD) in the power circuit, with residual current rating not more than 30 mA.
Contact professional electrician in this matter.
DESCRIPTION OF THE DEVICE
1. Shear length regulator
2. Switch
3. Shaver body
4. Blade guard
USE OF FABRIC SHOULDER
The shaver can be powered from the battery or from the mains.
1. Turn on the shaver.
2. Place clothing (fabric) on a flat surface, smooth wrinkles and move the shaver over the material in the front and back.
3. It is difficult to remove removable knots by shifting the shaver across and then along ("checkered") on the same small fragment of
clothing.
4. Thin clothing can be depreciated by folding it into several layers, applying it on a flat, stiff cardboard.
5. For fabrics with a pattern, move the shaver in the direction of the pattern.
5. Tassel and lump tank
6. Power socket
7. Battery chamber cover
8. Toothbrush
9. Power supply
4