Installation - Thermo IEC Medilite Vereinfachte Bedienungsanleitung

2

INSTALLATION

1. After unpacking, place the unit on a clean, level surface. The
2. Lift the lever to release the latch. Remove the soft material
3. Press down on the center hub to ensure that the rotor is secured to
4. Inspect the shields for damage. Make sure the flange of the shield
5. Plug the unit into a 120 VAC +/-10%, 50/60 Hz (Cat. Nos. 448 and
The unit requires minimal assembly before use.
surface must be level to ensure quiet, vibration-free operation.
A rigid, stable location is important because an improperly loaded
unit can vibrate or move.
covering the plastic shields (6 or 12) that are shipped in position
inside the rotor.
the shaft. Turn rotor by hand to verify it turns freely.
is flush with the surface of the rotor.
458) or a 220/240 VAC +/- 10%, 50/60 Hz (Cat. Nos. 449 and
459).
Medilite Operation Manual
4