Haier ES8V-Q1 Bedienungsanleitung Seite 9

Use
Operational Method
For the first using after installation, the water inlet valve of tap water should be
opened firstly since there is not water in the inner pot, and turn off the valve
after the inner pot is water filled and water comes out continuously from the
water outlet.
Check each connection for leakage. Turn on the power (If power switch is
installed on the machine, it needs to be closed off) and the heating indicator
lights up, and the electric water heater starts heating. Turn the knob according
to the heated water temperature required. Heating temperature can be
selected steplessly through the knob mark from the water inlet temperature to
75 C in an low to high order, and the indicator will light up in the heating
o
condition.
The heater controls temperature automatically. It will cut off power supply
when the temperature reaches the setting value. When the water temperature
decreased to a certain value, the red indicator will light up again and continue
heating. Such circulation will ensure hot water supply at any time.
During normal heating, a small amount of water may come out from the water
outlet pipe of safety valve. This is normal; if a large amount of water comes
out from the water outlet pipe of safety valve, it means the cold water pipeline
pressure is ≥0.7MPa(ES10V-Q1/Q2),0.75MPa(ES8/15V-Q1/Q2,ES30V-Q1)
and the user is advised to turn down the water inlet valve or contact our
after-sales to purchase a relief valve.
Precautions for use
Never turn on the power before the inner pot is fully filled to avoid damage to
the machine.
When using, take care to release cold water before discharging hot water to
avoid burning.
During using, check the safety valve once a month by turning the small handle
of the safety valve. If there is water comes out, it means the safety valve
works normally. If there is no water comes out, please contact your local
after-sales department.
9