Troubleshooting - Samsung SSG-S3000GR Handbuch

When viewing a 3D video under a fluorescent lamp (50 Hz – 60 Hz) or 3-wavelength lamp, you
may notice a small amount of screen flickering.
✎ If so, dim the light or turn the lamp off.
Selecting a menu option on the TV may disrupt the audio output.
If the 3D glasses move outside of the effective range of signal reception, the signal from the
TV will disconnect and the display and audio for the 3D glasses will turn off after 3 seconds.
The 3D glasses will automatically power off 30 seconds after the display turns off. When this
happens, the red LED will turn on for 3 seconds.
✎ If you move outside of the recommended range of use for a brief period of time, 3D
operation and audio may be disrupted.
If you lie on your side while watching TV with 3D active glasses, the picture may look dark or
may not be visible.
The 3D glasses may not function properly if there are any nearby 3D products or
electromagnetic devices (a microwave or a device that uses 2.4 GHz-bandwidth frequency
such as an Internet router) turned on. If an unintended operation of the 3D function occurs, it
is best to remove nearby electromagnetic devices or wireless communications devices.
If a lens or any part of the 3D glasses is defective or damaged, the glasses cannot be repaired
and should be exchanged. Broken 3D glasses can be exchanged for a new pair free of charge
within the warranty period. Note that damage caused by the fault of the user is not covered by
the warranty.
‹ Installation Guide
In the 3D Video Sync menu, set Current Mode to Stand-Alone or Master.
✎ Audio is not available in Slave mode.
Audio connection is available only in 3D mode under Shop mode. It is not available in 2D mode.
Attach the lock device to the lower part of the handle on the glasses.

Troubleshooting

Issues Try This.
¾
Ensure that your Samsung TV and 3D glasses are within
a distance of 6m.
¾
The 3D glasses do not function. Check the 3D function settings on the TV.
¾
Check that the audio is connected in the Setup menu.
¾
Press the reset button and then press the power button.
The red LED of the power button blinks continuously. ¾
The battery is low. Charge the battery.
The LED in the power button blinks from red to
¾
Press the reset button, and try pairing again.
green continually during pairing.
Product specifications (model name: SSG-S3000GR)
Shutter Liquid crystal shutter Transmission rate 37±2%
Optical properties
Recommended viewing
2~6m Field rate
distance
Weight Glasses 150g
Power Glasses 3.7V Lithium-polymer battery x 1
When both the glasses and
70mA
audio are turned on
When only the glasses are
4mA
turned on
Power
Type 650mAh, 3.7V
consumption
When both the glasses
Battery and audio are turned on
Run time
When only the glasses
are turned on
Operating temperature 0°C ~ 40°C (32 °F ~ 104 °F )
Operating
conditions
Storage temperature -20°C ~ 60°C (-4 °F ~ 140 °F)
✎ Specifications of this product are subject to change without notice to improve quality.
120 fields/s
10 hours (when the
sound is at a medium
volume level)
160 hours
English-3