Tecknet BLUETEK iEP360 Benutzerhandbuch Seite 4

2. Recharging your devices
There is an on/off power switch on the BLUETEK™ iEP360
Power Bank. Upon Pressing the "switch button" and the "LED
power indicator" will illuminate for 2 to 3 seconds. After that, the
Power Bank will start charging your devices. To stop charging
your device, simply disconnect the device from the BLUETEK™
iEP360 Power Bank. The power output will remain for 30-35 seconds
and automatically switch off if the Power Bank is not connected
with any device within this period.
Battery Capacity Indicator & LED Light Switch Button
The LED power indicators provide information about the battery
charging status and battery power level:
Press the "switch button" to check power level, the LEDs will
illuminate for 30~50 seconds.
LEDs indicate:
1 LED Flashes: <20% Power
2 LED on: 40% Power
4 LED on: 80% Power
LED Torch
There is a LED Torch located at the front of the Power Bank.
To switch it on, short press the Switch Button twice; and to switch it
off, short press the Switch Button twice again.
Maintenance
In order to maximize the battery life, please maintain your BLUETEK
™ iEP360 Power Bank as recommended below:
1. Re-charge your BLUETEK™ iEP360 Power Bank once every
three months if it has not been in use.
2. Keep your BLUETEK™ iEP360 Power Bank dry and away from
moist or corrosive materials.
1 LED on: 20%Power
3 LED on: 60% Power
5 LED on: 100% Power
3