Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Setup Menu
Modified Setup Menu Items
When this board is installed in the HDW-1800/D1800, the
settings of setup menu items 005 and 013 change as
follows.
Item number
Item name
005
DISPLAY INFORMATION
SELECT
013
SYSTEM FREQUENCY
SELECT
Newly Added Setup Menu Items
When this board is installed in the HDW-1800/D1800, the
following items are automatically added to the setup menu.
Item number
Item name
018
ACTIVE LINE SELECT
(disabled in 24PsF,
23.98PsF, 24PD, and
23.98PD2 mode)
Underlines indicate the factory default settings.
Settings
Determine the type of text information to be output from the COMPOSITE
VIDEO OUTPUT 3 (SUPER), SDI OUTPUT 3 (SUPER) and HDSDI OUTPUT
3 (SUPER) connectors when F5 (CHARA) is set to "ON" in function menu
page P04: MISC-1.
T&STA: Time data display information and the unit's status (in pulldown
mode, both post-pulldown timecode and operating status)
T&UB: Time data display information and the user bits (in pulldown mode,
both post-pulldown timecode and user bits)
T&CTL: Time data display information and CTL (in pulldown mode, both post-
pulldown timecode and pre-pulldown timecode)
T&T: Time data display information and timecode (LTC or VITC) (in pulldown
mode, both post-pulldown timecode and pre-pulldown timecode)
TIME: Timecode (LTC or VITC) only (in pulldown mode, post-pulldown
timecode only)
If there is an overlap between the setting of this item and the setting of the
control panel, it is automatically avoided. For example, if CTL is selected on
the control panel and this menu item setting is "T&CTL", then CTL and LTC are
output.
Determine whether to enable switching of the system frequency among
59.94i, 50i, 29.97PsF, 25PsF, 24PsF, 23.98PsF, 24PD, 23.98PD1, and
23.98PD2.
OFF: Disable switching.
ON: Enable switching.
When "ON" is selected, the menu display changes to allow switching of the
setting among 59.94i, 50i, 29.97PsF, 25PsF, 24PsF, 23.98PsF, 24PD,
23.98PD1, and 23.98PD2.
For details on the procedure for changing the system frequency, see "To
switch the system frequency (menu item 013)" in the 1st Edition (Revised 1) of
the Operation Manual.
Underlines indicate the factory default settings.
Settings
Determine whether to enable switching of the number of active lines for
HDSDI outputs (OFF TAPE/720P).
OFF: Disable switching.
ON: Enable switching.
When "ON" is selected, the menu display changes to enable OFF TAPE/
720Pswitching.
For details on the procedure for switching the ACTIVE LINE, see "To switch
the line conversion function (menu item 018)" in the 1st Edition (Revised 1) of
the Operation Manual.
13
Setup Menu
Werbung
