Inhaltsverzeichnis
Werbung
flammable materials.
Never use in an explosive environment.
Never leave the heat gun unattended.
Let the device cool at a suitable location after use
before putting it away.
Never use the device with chemical solvents.
Never carry the heat gun by the cord and don't
pull the plug out of the socket by the cord.
Never aim the hot air blast at the cord.
When using an extension cable, make sure that it
is heat resistant.
Making your own modifications or changes to the
electrical device is not permitted for safety and
certification reasons (CE). Damaged power cords
may only be replaced by an authorised specialist.
The configuration of the heat gun complies with
protection class 2 (double insulation). Make
sure that the insulation of the casing is neither
damaged nor destroyed.
Make sure that all electrical connections and
connection lines between the heat gun and any
extension cables, if applicable, are in approved
condition.
Never work with the heat gun over water. Never
pour liquids over the heat gun. There is a serious
danger of a critical electrical shock or a fire. If this
happens, immediately pull the power plug and
contact a specialist.
If the device is brought from a cold room into
a warm one, let it reach room temperature
first before plugging it in. Under unfavourable
conditions, the resulting condensation water can
destroy your device.
In order to avoid the danger of an electric shock,
never touch the device with wet or damp hands.
Never leave children unattended if they are
around the heat gun. Children might try to put
objects into the heat gun. There is danger to life
from an electrical shock!
The device must be unplugged before assembly
or cleaning and during extended periods of
disuse.
The heat gun must not be operated if hazard-free
operation is no longer possible.
Hazard-free operation is no longer possible if the
device:
• or the power cord have visible damage
• no longer works
• has been stored for an extended time under
unfavourable conditions
• has been subjected to harsh transport
conditions
Device Components (B1)
1. On/Off power switch
Start-up
Plug in the heat gun.
With the help of the multi-position switch (1) in
the handle of the heat gun, select the desired
temperature and volume of air (B1).
Setting 1
350 °C - 300 l/min - 1000 watts
Setting 2
550 °C - 500 l/min - 2000 watts
The power setting and the distance from the
object being worked on are dependent on
the type of material and the desired type of
processing. Always conduct a test before starting.
The heat gun is suitable for manual and standing
GB
7
Werbung
Inhaltsverzeichnis
