AGA AQVIA BALANCE Bedienungsanleitung Seite 7

Removing the gas cylinder
Place the carbonator on a flat surface and remove the back cover of the machine:
GB
hold in the catches on the side and angle the cover backwards and then lift it
upwards. Unscrew the cylinder, at which point the sparkling water maker will tip
forwards slightly. Tilt the sparkling water maker a little further forwards and lift out
the cylinder.
Filling the water bottle
Clean the bottle before use. Do not use water
hotter than 40 C. Fill the bottle with cold water
o
up to the maximum volume mark. If the bottle
is overfilled, water can enter the machine
and leak out. For best results, use cold water;
the colder the water, the greater the volume
of gas that can be dissolved. It is therefore a
good idea to store an extra bottle of water in
the fridge. Make sure, however, not to keep
the water for too long in the bottle as it might
become stale.
Important! Never carbonate anything other than pure drinking water, as sugar
or other additives might cause the pressure relief valves to stick, rendering the
machine unsafe to use.
7