Rear View - Sony PWS-100RX1 Bedienungsanleitung

a FAN indicators
If any of the fans fail, the corresponding fan indicator turns
on red.
b POWER indicators
If either of the AC power supply units fail, the
corresponding indicator turns on red.

Rear View

a SYSTEM TC connector
Input a timecode signal.
b Remote connectors (1/2, 3/4, 5)
Not used by this system.
c AC power supply units
Insert the power cords and connect to power outlets.
Only one AC power supply unit is installed at the factory.
A second power supply unit can be installed to provide
power supply redundancy. When used in systems that
require reliability, power supply redundancy allows the
unit to continue operating even if a power supply unit fails.
For details about installing or replacing a power supply
unit, consult your Sony sales or service representative.
d SDI (1 to 4) connectors
SDI1 to SDI4 connectors are numbered from left to right.
Outputs SDI signals.
e REF IN connectors
Input sync reference signals.
f USB connectors (rear panel)
Connect to a keyboard and mouse.
USB devices not described in this document are not
supported.
1
LAN1 LAN2
4 5 6 7
c TEMP indicator
If an abnormally high temperature is detected within the
unit, the indicator turns on red.
2 3
1 1 2 3 4 5
6 8 9
Notes
• Of the four USB connectors on the rear panel, only the bottom right port
supports power delivery (900 mA). The other three ports do not support
power delivery, and should be used to connect USB devices that do not
require power supplied from the USB connector.
• Use SuperSpeed USB cables.
g LAN connectors
Connect to a Gigabit Ethernet network.
h HDMI connector
Connect to a monitor using an HDMI cable.
Use only Sony-brand HDMI cables.
Recommended cable (example): DLC-HE20XF HIGH
SPEED HDMI cable (2 m (6 ft.))
i DisplayPort connector
Not used by this system.
15
Name and Function of Parts