Lindy 39371 Benutzerhandbuch Seite 2

Overview
Thank you for purchasing the LINDY KVM Extender Classic. This product
allows you to control your PC using a keyboard, mouse and monitor with
a maximum resolution of Full HD 1080p or 1920x1200 at distances of up
to 50m (150 feet) using inexpensive CAT6 cable. It supports HDMI signals
including 3D, 1080p24 Blu-ray, audio and HDCP.
The KVM Extender Classic consists of a Transmitter unit which is installed
near the computer and a Receiver unit installed near the user console. The
Receiver unit connects to a USB keyboard and mouse, HDMI monitor and
offers a Stereo audio port via 3.5mm connector.
The Transmitter unit offers the same connections and in addition, an
optional local console port (bypass).
Features
 Provides a real-time convenient method of remotely controlling PCs
 Supports USB keyboard and mouse signals
 High resolution video support of up to Full HD 1080p, 3D, HDCP, Audio
and 1920x1200 for up to 50m
 Easy, user-friendly installation - no software required
Packaging Contents
 Local Transmitter and Remote Receiver unit
 5V DC / 100...240V AC Power Adapter x2 (with multi-country adapters
for EUR, UK, US, AUS/China)
 1x USB to PC A/B cable (for Transmitter)
 This manual
Installation and Use
English
The Extender units have a magnetic base and metal installation plate for
easy fixing in or under a shelf or wall. To detach the metal plate from the unit,
simply pull it off.
To connect the transmitter and receiver unit, Cat.6 STP cable provides the
best results. Do NOT use a LAN/Ethernet connection. You must always
use a dedicated direct cable! Adding any additional connections in-
between like wall outlets etc. will result in reduced distances!
If you intend to use a distance of more than 25m or if you want to lay cables
inside a cable duct, please first test your RJ45 cables in a test installation
with the extender BEFORE you install them in your wall or cable duct!
The extender does not transmit EDID monitor data. It uses a default EDID
data set with common Full HD 1080p resolutions. If you intend to use a
monitor with special resolution and EDID data, you must copy the monitor
English
EDID data into the transmitter unit. To do so, disconnect all connections from
the transmitter, set both DIP switches to OFF/up position; connect
the monitor to the HDMI OUT port and power on monitor and
transmitter. After a few seconds, when the yellow RJ45 port LED
has flashed once, the EDID data has been copied permanently.
Unplug the monitor and set DIP switch No.2 to ON/down position. If you set
both DIP switches to ON position, the default EDID data will be used.
English
1. Transmitter Unit
Connect the Cat.6 RJ45 cable to the RJ45 port.
Connect the HDMI and the USB A/B cables to the transmitter and to your
computer. If you want to use the 3.5mm Stereo signal, please also connect
this port to your computer. If you want to use the optional local console just
connect your mouse, keyboard, monitor and stereo device.
Connect the power supply to the transmitter.
Please test the functionality of keyboard, monitor, mouse and speaker, to
make sure they are working properly with the transmitter unit.
2. Receiver Unit
Connect the Cat.6 RJ45 cable to the RJ45 port.
English