English - Kreafunk PD-07 Handbuch

2. aSound is on standby mode after
power-on if the LED blinks quickly.
3. aSound will turn off for power saving
if it is not in use in 10 minutes.
4. Press the power button located
on the top to activate aSound from
standby mode.
5. To manually turn off aSound
Speaker, pres and hold the power
button.
4� Pairing with Bluetooth
enabled devices
(Mobile phones/Tablets etc.)
1. Keep the speaker and device within
1 meter of each other.
2. Hold down the power button for 2
6

English

seconds to turn on the speaker, the
LED indicator will blink quickly while the
speaker enters search mode.
3. Pres the bluetooth button once.
Start the Bluetooth function on your
mobile device and look for "aSound"
in the Bluetooth device list (depending
on the Bluetooth version of your device
you may have to enter the pass code
'0000').
4. After successfully connecting, the
LED will stop blinking.
Note:
- If the pairing was not successful, turn
off the speaker and re-pair again.
- After successful pairing, paired
devices will remember each other so
there is no need to pair again unless
pairing information is deleted.
7
English