Specifications; General; Input/Output Ratings; Audio Performance - Tascam MX-8A Bedienungsanleitung

Specifications

General

FORMAT
44.1k/48kHz,16bit/24bit

Input/output ratings

USB port
Connector: 4-pin USB B-type
Transfer rate: USB 2.0 High Speed (480 Mbps)
ANALOG IN connectors
Connector: Euroblock (balanced) 3.81 mm pitch
Minimum input level: -77.5 dBu
Maximum input level: +26 dBu (MIC)
Maximum input level: +24 dBu (LINE)
Input impedance: 2.2 kΩ or higher
ANALOG OUT connectors
Connector: Euroblock (balanced) 3.81mm pitch
Nominal output level:
+4dBu (when Ref.Level set to other than -9dBFS)
+6dBu (when Ref.Level set to -9dBFS)
Maximum output level (switchable):
+15dBu (Ref.Level: -9dBFS)
+18dBu (Ref.Level: -14dBFS)
+20dBu (Ref.Level: -16dBFS)
+22dBu (Ref.Level: -18dBFS)
+24dBu (Ref.Level: -20dBFS)
Output impedance: 200 Ω or lower
RS-232C connector
D-sub 9-pin (female, inch-standard)
RS-485 connector
Connector: RJ-45
Cables: category 5e or faster STP cables
Ethernet connector
Connector: RJ-45
Transmission protocol: TCP/IP
Ethernet standard: 100BASE-TX
Cables: category 5e or faster STP cables
0 0dBu=0.775Vrms
12
TASCAM MX-8A

Audio performance

Mic amp EIN (equivalent input noise)
-126 dBu or less (MIC IN w LINE OUT, Input impedance: 150 Ω,
22 kHz LPF, A-weighted, JEITA)
Frequency response
±0.5 dB: 20 Hz – 20 kHz
(+24 dBu input, MIC IN w LINE OUT, GAIN MIN, JEITA)
Distortion (THD+N)
0.005% or less
(+24 dBu input, 1 kHz, MIC IN w LINE OUT, GAIN MIN,
JEITA)
S/N ratio
106 dB or higher
(+24 dBu input, 44.1 k/48 kHz sampling frequency, MIC IN
w LINE OUT, GAIN MIN, JEITA)
Crosstalk
106 dB or higher
(+24 dBu input, 1 kHz, MIC IN w LINE OUT, GAIN MIN,
JEITA)
Dynamic range
106 dB or higher
(MIC IN w LINE OUT, GAIN MIN, JEITA)
Note: JEITA indicates compliance with JEITA CP-2150

Other

Power
AC100-240 V, 50/60 Hz
Power consumption
21W
Dimensions
483 × 45 × 304.1mm (W x H x D, including protrusions)
Weight
3.0kg
Operating temperature range
0°C–40°C
0 See the back of this manual for dimensional drawings and lev-
el and block diagrams.
0 Illustrations in this manual might differ in part from the actual
product.
0 Specifications and external appearance might be changed
without notification to improve the product.