Important Safety Reminders; Getting Started - Hoover SENSORY Bedienungsanleitung

05655077_NEW 8/10/02

IMPORTANT SAFETY REMINDERS

This cleaner should only be used for domestic cleaning as described in these
instructions. Please ensure that these are fully understood before operating
this appliance. This product is double insulated and must not be earthed.
IMPORTANT: The wires in the power cord are coloured in accordance with the
following code:
Blue - Neutral
13 Amp fused plug on UK versions only.

GETTING STARTED

By following this step-by-step guide your new Hoover Sensory will be ready
for use:
• Remove cleaner and accessories from packaging. Please dispose of the
packaging in a safe and environmentally conscientious way.
• Open the top cover (A) ensuring that the bag (B1), pre-motor filter (B2) and
exhaust filter (B3) are fitted correctly. Close the top cover.
• Insert the hose end into the top cover, ensuring it clips and locks into
position (C). To release simply press in the two latches and pull.
• Fix the free end of the hose into the handle using the lock ring (D).
• Fit extension tubes (E1), floor nozzle (E2), and other accessories as required
for use.
• Your Sensory is now ready for use. Extract the plug and pull out all of the
cord. Plug in and switch on.
FEATURES - Depending on model, please see Sensory Specification List
• On/Off button (F). Once plugged in, press this button to start the cleaner.
Press it again to stop the cleaner before removing the plug after use.
• Cord rewind button (G). Remove the plug from the power supply. Press this
button to wind the power cord back into the cleaner.
• Electronic Bag Check Indicator. (H)
When activated this device warns that,
a) On models fitted with Active Power Sensor. The device flashes to warn you
that the bag is near full, the quicker the flash the closer the bag is to
being full. If the light is on continuously, depending on model, change the
paper bag or empty the Permanent bag. Please refer to chapter "Replacing
the bag / Emptying the permanent bag".
b) On models without Active Power Sensor. The device illuminates to warn you
that the bag is full. Please refer to chapter, "Replacing the bag / Emptying
permanent bag".
C) On all models. If after changing the paper bag or emptying the Permanent
bag the light is still illuminated or flashing a blockage has occurred.
Please refer to chapter "removing a blockage from the system".
• Safety Stop (depending on model). Cleaner automatically goes into "Safety
Stop" mode indicated by the Bag Check Indicator flashing. This happens if the
product is used for longer than 10 minutes with the Bag Check Indicator
illuminated. Switch off the product, check bag and replace/empty permanent
bag (depending on model) if full, or check and remove possible blockage. To
re-start switch on the product.
• Thermo Protection Switch. Cleaner automatically switches off.
• In this event extract the plug from the socket and allow cleaner to cool
for 30 minutes. Check if there is any blockage in the system and remove (see
chapter: "Removing A Blockage From The System").
• Fixed power control (depending on model). Adjust the suction by moving the
hose handle valve (I): suction will decrease when opening the valve. Use low
suction for delicate fabrics.
• Variable power control (J) (depending on model). Rotate the on/off button
to increase or decrease suction. Use low suction for delicate fabrics.
• Active Power Sensor mode (depending on model). Rotate the on/off button
(J) to select Active Power Sensor. The cleaner will keep a constant
performance during the majority of the cleaning operation. A slight drop in
performance will occur when the bag is near full, indicated by the flashing
light. IMPORTANT: Manually select low power setting for delicate fabrics.
11:46 AM Page 7
Brown - Live
GB