Herunterladen Diese Seite drucken

Carmen CT3000 Gebrauchsanweisung Seite 52

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

52 • English
and hard to straighten hair.
Note!
Due to the high temperatures the sulfur and hydrogen bonds
contained in the hair will be opened, whereby the formability
of the hair is enhanced.
Straightening hair (see figures 5 – 7)
Hold the appliance at the handle h, always at a safe distance
from skin and eyes. Use a mirror.
• Part your hair into approx. 2-3 cm, not too thick, strands.
• Begin at the roots and lay the prepared strands one at a
time between the heating plates e (see fig. 5).
• Close the appliance and draw the hair straightener slowly
from the roots through to the tips of your hair (see fig. 6
and 7). Repeat until your hair is as straight as you desire.
• After finishing styling, let your hair cool down and then
comb it through.
Curling (see figures 8 – 11)
• Separate your hair into approx. 2 cm strands.
• Open the appliance and position it so that the prepared
strand lies at the back between the V-shaped heating plates
e which lying together (see fig. 8). Keep a distance of at
least one appliance width to the roots.
• Close the appliance (see fig. 9) and turn it so that the strand
lies on the curl forming surface d (see fig. 10).
• Now tilt the appliance downwards a little by lowering the
handle towards the shoulder and then draw the appliance
in this position slowly from the roots to the tips of your hair
(see fig. 11).
The heated strand will be formed into a curl due to the smooth
forming surface d.
A larger angle forms a more twisted curl. Repeat until your hair
is as curly as you desire.
Note!
Best results are achieved when the external curl forming
surface d is still cold. With increasing use this warms up with
the heat given off from the hair.
Crimping (see figures 12 – 15)
• Part your hair into approx. 4-6 cm, not too thick, strands.
• Begin at the roots and lay the prepared strands one at a
time between the heating plates e (see fig. 12).
• Close the appliance and allow the heat to take effect for
approx. 4-5 seconds (see fig. 13).
• Release the strand, now turn the appliance 180° and

Werbung

loading