Maestro MR261 Bedienungsanleitung Seite 7

EN
Operation
Before startup
- Remove all wrap materials and stickers
- Make sure that all the parts of appliance don't have damages.
- Unwind the power cord completely.
- Place the device on a flat dry heatproof surface.
- Connect the device to the mains.
The hair must be clean, dry and brushed.
ATTENTION! A small quantity of smoke or a specific smell may
appear after the first switching ON as the result of conservation
materials contact with heating element. This is a normal
phenomenon and it shall disappear after several minutes of
operation.
- Place the switch (2/Fig. 2) to the position «ON». Light indicator (3/
Fig.1) will go red and the tongs will begin heating.
- The heating up takes about 1 minute.
- When the set temperature is reached the light indicator becomes
green and the device is ready for operation.
- For setting hair, divide it into three parts: upper, middle and lower.
- Brush each forelock before straightening. Begin from the lower
part. When lower strands are completely straightened, proceed to
the next row in a circle.
- Take a strand of hair about 5 cm thick, press it strongly and pull
down from the roots to the ends. Keep the device with one hand
fixing the hair between the plates.
- Keep the plates together pulling the tongs down along the
whole length of hair from the roots to the ends with one smooth
movement. If the strand is not straightened enough repeat the
movement. Repeat it till the hair is quite straitened.
7