Set Volume Mode; Use With Mobile Phone; Pairing; To Make A Call - Cellink BTST-9000D Handbuch

6 Set volume mode

1.5 seconds
Normal volume mode
- Press and hold the control buttons on the stereo adapter for 1.5 seconds to disconnect the
stereo adapter from the audio device.
- Single click on the control button will reconnect the stereo adapter to the audio device and set
the stereo headset to normal volume mode.
High volume mode
- Press and hold the control buttons on the stereo adapter for 1.5 seconds to disconnect the
stereo adapter from the audio device
- Double click on the control button will reconnect to the stereo adapter to the audio device and
set the stereo headset to high volume mode.
Note:
- For iPod, normal mode is preferred.
- For Sony PSP or Creative MP3 player and others, high volume mode is preferred.
6

Use with mobile phone

1 Pairing

Press and hold the pairing/track wheel button on the stereo headset for 6 seconds to set the stereo
headset into pairing mode. The blue and red LEDs will be flashing when the stereo headset is in
pairing mode. To properly perform pairing procedure on your mobile phone, please refer to the
manual of your mobile phone for its own pairing instruction. This device name is set to be "Bluetooth
Stereo Headset". If you are asked to enter pin-code during pairing, please enter 1234. (Note: The
"1234" is default pin-code pre-stored in this Stereo headset.)

2 To make a call

- Dial out the number from your mobile phone.
- Voice is automatically transferred to the headset.

3 To receive a Call:

1. When there is an incoming call, press the answer button to answer the call and the audio channel
will be switched to the mobile phone.
2. Press the Volume control button to adjust the volume.
3. When finish talking, press the answer button to end the call and the audio channel will be
switched back to the audio device.

4 To reject a Call

- Press the reject button on the mobile phone to reject a call.
7